EasyManua.ls Logo

Sharp R-230HW

Sharp R-230HW
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
35
R-203HW
R-220HW
R-230HW
MICROWAVE OVEN
In the interest of user-safety the oven should be restored to its original
condition and only parts identical to those specified should be used.
WARNING TO SERVICE PERSONNEL: Microwave ovens con-
tain circuitry capable of producing very high voltage and
current, contact with following parts may result in a severe,
possibly fatal, electrical shock. (High Voltage Capacitor, High
Voltage Power Transformer, Magnetron, High Voltage Recti-
fier Assembly, High Voltage Harness etc..)
TABLE OF CONTENTS
Page
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO
AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY ...................INSIDE FRONT COVER
BEFORE SERVICING ......................................................................................................INSIDE FRONT COVER
WARNING TO SERVICE PERSONNEL................................................................................................................ 1
MICROWAVE MEASUREMENT PROCEDURE ...................................................................................................2
FOREWORD AND WARNING............................................................................................................................... 3
PRODUCT SPECIFICATIONS ..............................................................................................................................4
GENERAL INFORMATION................................................................................................................................... 4
OPERATION ..........................................................................................................................................................6
TROUBLESHOOTING GUIDE ..............................................................................................................................9
TEST PROCEDURE ............................................................................................................................................10
TOUCH CONTROL PANEL .................................................................................................................................18
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE ................................................................ 22
PICTORIAL DIAGRAM ........................................................................................................................................28
CONTROL PANEL CIRCUIT ...............................................................................................................................29
PRINTED WIRING BOARD .................................................................................................................................30
PARTS LIST ........................................................................................................................................................30
PACKING AND ACCESSORIES .........................................................................................................................34
S2303R220HPW/
R-203HW
R-220HW
R-230HW
MODELS
SERVICE MANUAL
SHARP CORPORATION
This document has been published to be used for after
sales service only.
The contents are subject to change without notice.
R-230HW

Questions and Answers:

Sharp R-230HW Specifications

General IconGeneral
BrandSharp
ModelR-230HW
CategoryMicrowave Oven
LanguageEnglish

Summary

Precautions for Microwave Exposure Safety

Before Servicing Procedures

Service Personnel Warnings

Pre-Servicing Safety Steps

Steps to take before servicing the oven, including disconnecting power and discharging capacitors.

Microwave Measurement Procedure

Leakage Test Execution

Procedure for performing the closed-door microwave leakage test.

Foreword and Introduction

General Operating Warnings

Essential conditions and checks before operating or servicing the oven.

High Voltage Danger Warnings

Identifies high-voltage parts that pose a severe shock hazard during servicing.

Operation Sequence and Power Levels

Component Descriptions and Functions

Troubleshooting Guide

Troubleshooting Blown CT Fuse

Specific checks and replacements required when the C/T fuse blows.

Troubleshooting Safety and Procedures

General safety precautions and procedures for performing troubleshooting.

Test Procedures Overview

Magnetron Assembly Test

Procedure for testing the magnetron assembly for proper operation.

Component Testing Procedures

Microwave Output Power Test

Procedure for measuring microwave power output using a water temperature rise test.

Power Transformer Test

Procedure for testing the power transformer resistance and continuity.

Component Testing Procedures (Continued)

High Voltage Rectifier Test

Procedure for testing the high voltage rectifier assembly.

Primary Interlock System Tests

Tests for door sensing switch and primary interlock relay operation.

Blown CT Fuse Test

Procedure to test for a blown C/T fuse and related safety switches.

High Voltage Capacitor Test

Procedure for testing the high voltage capacitor for shorts or opens.

Touch Control Panel Test

Procedure for testing the touch control panel assembly.

Touch Control Panel Assembly Details

Servicing Procedures and Precautions

Handling Electronic Components

Precautions for handling CMOS LSI and preventing static damage.

Touch Control Panel Servicing

Procedures and precautions for servicing the touch control panel.

Component Replacement and Adjustment

High Voltage Warnings for Servicing

Critical warnings about high voltage hazards during component replacement.

Microwave Energy Exposure Precautions

Precautions to avoid microwave energy exposure before operating the oven.

Wiring Safety Precautions

Essential precautions to prevent electric shock when working with wiring.

Component Replacement and Adjustment (Continued)

Magnetron Removal

Procedure for removing the magnetron from the oven.

Control Panel Assembly Removal

Cooling Fan Motor Removal

Door Switches and Monitor Switch Removal

Door Replacement Procedure

Ordering Replacement Parts

Related product manuals