Sharp R-4A54

R -4A54
R-4A54B
POWER SUPPLY CORD REPLACEMENT
(FOR AUSTRALIA MODEL)
Removal
1.
2.
3.
4.
5.
6.
CARRY OUT 3D CHECKS.
Disconnect the brown wire of the power supply
cord from the fuse holder.
Remove the connector CE-230 by cutting the con-
nected wire leads to it.
Remove the single (1) screw holding the
green/yellow wire of the power supply cord to the
oven cavity.
Remove the single (1) screw holding the cord
anchorage to the oven cavity.
Remove the power supply cord from the oven.
Re-install
Main harness
1.
2.
3.
4.
Insert the power supply cord into the cord
anchorages.
Connect the brown wire of the power supply cord
to the fuse holder.
Install the green/yellow wire of the power supply
cord to the oven cavity with the single (1) screw
tightly.
Make sure that the blue wire and the white wires
are stripped for 15 MM length as shown illustlation.
1.
2.
3.
4.
5.
6.
5. Wind the conductors of Blue and White wires each
other.
6. Insert the stripped wire leads into the connector
CE-230.
7. Clamp the connector CE-230 with the correct tool
tightly.
pro anchorage
Brown wire
I
Power supp ty
cord
/
/
CE230 ’
Green/Yellow wire
I
1‘
Blue wire
Figure C-4 Power Supply Cord Replacement
for Australia Model’
UPPER LATCH SWITCH, LOWER LATCH SWITCH,
STOP SWITCH AND MONITOR SWITCH REMOVAL
CARRY OUT 3D CHECKS.
Mcmitor switch
Remove the air duct from the oven cavity.
Disconnect the leads from all switches.
Remove the two (2) screws holding the latch hook
to the oven cavity.
Remove the latch hook.
Upper latch switch
Push the retaining tab slightly and remove the
switch.
ower latch switch
Figure C-6. Switches
14