Sharp R-80A0S

5
Power Level Press the MICRO.POWER
button
Display
(Percentage)
HIGH
x1 P100
x2 P 90
MEDIUM HIGH
x3 P 80
x4 P 70
MEDIUM
x5 P 60
x6 P 50
MEDIUM LOW
(DEFROST)
x7 P 40
x8 P 30
LOW
x9 P 20
x10 P 10
x11 P 0
Generally the following recommendations apply:
- (HIGH) used for fast cooking or reheating
e.g. for casseroles, hot beverages, vegetables etc.
- (MEDIUM HIGH) used for longer cooking of
dense foods such as roast joints, meat loaf and plated
meals, also for sensitive dishes such as sponge cakes.
At this reduced setting, the food will cook evenly
without over cooking at the sides.
- (MEDIUM) for dense foods which require a
beef casserole, it is advisable to use this power setting
- (MEDIUM LOW) to defrost, select this
- (LOW) For gentle defrosting, e.g. cream
Plug in the oven. The oven display will display: “0:00”, an audible signal will sound once.
This model has a clock function and the oven uses less than 1.0 W in stand by mode.
To set the clock, see below.
BEFORE OPERATION
SETTING THE CLOCK
MICROWAVE POWER LEVEL
There are two setting modes: 12 hour clock and a 24 hour clock.
1. To set the 24 hour clock, press the CLOCK/KITCHEN TIMER button once and “24H” will appear in the display. To
set the 12 hour clock, press the CLOCK/KITCHEN TIMER button once more and “12H” will appear in the display.
2. Rotate the ENTRY dial until the correct hour is displayed, the input time should be within 0-23 (24-hour
clock) or 1 -12 (12-hour clock).
3. Press the CLOCK/KITCHEN TIMER
ash.
4. Set the minutes. Rotate the ENTRY dial until the correct minutes are displayed, the input time should be
within 0-59.
5. Press the CLOCK/KITCHEN TIMER button once to start the clock. The icon “:” of the digital time will be
ashing on the display.
NOTES:
• If the clock is set, when cooking is complete, the display will show the correct time of day. If the clock has not
been set, the display will show “0:00”.
• To check the time of day during a cooking process, press CLOCK/KITCHEN TIMER button and the LED will
ect the cooking process.
•
In the process of clock setting, if the STOP/CLEAR button is pressed, the oven will go back to the former setting.
• If the electrical power supply to your microwave oven is interrupted, the display will intermittently show “0:00 ” after the
power is reinstated. If this occurs during cooking, the programme will be erased. The time of day will also be erased.
You may detect smoke or a burning smell when using the grill for the rst time. This is normal and not a sign that
the oven is not operating correctly. To avoid this problem, when rst using the oven, heat the oven without food for
20 minutes on grill mode.
• Your oven has 11 power levels, as shown.
• To change the power level for cooking, press the
MICRO. POWER button or rotate the ENTRY dial
until the display indicates the desired level. Press
the START/+1min/ENTER button to conrm, enter
the cooking time and then press the START/+1min/
ENTER button to start the oven.
• To check the power level during cooking, press the
MICRO. POWER button, the current power level will
be displayed for 2-3 seconds. The oven will continue
to count down although the display will show the
power level.
P100/ P 90
P 80/ P 70
P 60/ P 50
long cooking time when cooked conventionally, e.g.
to ensure the meat will be tender.
P 40/ P 30
power setting, to ensure that the dish defrosts evenly.
This setting is also ideal for simmering rice, pasta,
dumplings and cooking egg custard.
P 20/ P 10
gateaux or pastry.