Sharp R-8R51 - Page 35

Hi}
R 8R51(W)
R 8R4S11B)
OVEN LAMP SOCKET REMOVAL
— . CARRY OUT 3D CHECKS
2. Pull the wire leads from the oven lamp socket by Terminat
pushing the terminal hole of the oven lamp socket
with the flat type small screw driver,
3. Lift up the oven lamp socket.
4. Now, the oven lamp socket Is free. Wire lead
Fiat type small
screw driver
Oven lamp sockat
CAUTION: When replacing the oven lamp socket, re-
place it so that the side where the black rs
dot ts put faces upward.
Black dot
Terminal hole
Figure C-4. Oven lamp socket
POWER SUPPLY CORD REPLACEMENT
Removal
1. CARRY OUT 3D CHECKS.
2. Remove the single (1) screw holding the
green/yellow wire to the rear cabinet.
3. Disconnect the leads of the power supply cord Square hole of rear cabinet
from the noise filter, referring to the Figure C-1.
Positive Lock Connector.
4. Release the power supply cord from the rear cabi-
net,
5. Now, the power supply cord is free.
Re-install ee cabinet
1. Insert the moulding card stopper of power supply
cord into the square hole of the rear cabinet, refer-
ring to the Figure C-5. Installation of Power supply
cord.
Install the earth wire lead of power supply cord to
the rear cabinet with screw and tight the screw. Moulding cord stopper of power supply cord
3. Connect the brown and blue wire leads of power
supply cord to the noise filter correctly, referring to
the Pictorial Diagram. Figure C-5. Replacement of Power Supply
Cord
Power supply cord
~
DAMPER MOTOR AND DAMPER SWITCH REMOVAL
1. CARRY OUT 3D CHECKS 5. Remove the single (1) screws holding the damper
2. Disconnect the leads from damper motor and motor to the damper motor mounting plate. Now.
damper switch. the damper motor is free.
3.
Remove
the
single
(1)
screw
holding
the
damper
6.
Remove
the
single
(1)
screw
holding
the
damper
motor mounting plate to the partition plate T. switch to the damper motor mounting plate. Now,
4. Remove the damper cam from the damper motor. the damper switch ts free.
1ST LATCH, 2ND LATCH, 3RD LATCH, STOP AND MONITOR SWITCHES REMOVAL
1.
CARRY
OUT
3D
CHECKS.
3.
Remove
the
two
(2)
screws
hoiding
the
latch
hook
2.
Disconnect
the
wire
leads
from
the
all
switches
on
to
the
oven
cavity
flange.
and
remove
the
latch
:
;
sie
hook.
latch
hook.
a
a
(For
removing
2nd
iatch
switch,
3rd
latch
switch
or monitor switch}
33