R-9380
TEST PROCEDURES (CONT’D)
PROCEDURE
LETTER COMPONENT TEST
K
PROCEDURES TO BE TAKEN WHEN THE FOIL PATTERN ON THE PRINTED WIRING
BOARD(PWB) IS OPEN.
To protect the electronic circuits, this model is provided with a fine foil pattern added to the
primary on the PWB, and this fine pattern service as a substitute coil. If the foil pattern is open,
follow the troubleshooting guide given below for repair.
Problem: POWER ON, indicator does not light up.
ISTEPS I OCCURANCE
CAUSE OR CORRECTION
1
The rated voltage is not applied to POWER terminal Check supply voltage and oven main unit.
of CPU connector (CN-A)
2
The rated voltage.is applied to primary side of power Power transformer or secondary circuit defective.
transformer. Check and repair.
3
Only pattern at “a” is broken. ‘Insert jumper wire 31 and solder.
4
Pattern at “a” and “b” are broken. *Insert the coil RCILF2003YAZZ between “c” and
“d”.
NOTE:* At the time of these repairs, make visual in-
spection of the varistor for burning damage
and examine the transformer with tester for the
presence of layer short-circuit (check primary
coil resistance).
If any abnormal condition is detected, replace
the defective parts.
*; _ -” :‘ i
.:, ‘I ^
x ^,
&u+$ ,‘i
*; _, L.,,
I :,
rLlr
‘** ,.^
,; ‘;’
‘-1: >:;
G&, :p;e
.‘?,‘.,I:, “I ;,,
:“\ @ N _ A
VRS$
i_ ,,
,<:g;;; 3
P
,&:?;,:,g ,I ‘,px*&;&; 2 a=,, ,,-*;$‘;
.,,, _,’
:
(RD8: KO4U)
14
To Next Page
Loading...
