Home Appliances
EN-6
EN
Function instruction
This kettle has three kinds of function: boiling water, keep warm and boiling extend.
Function setting
1. State instruction:
There are two states for this electric kettle: setting state and working state. At setting
state, the icon of the function which is selected will be light and then parameters
can be set. At working state, the icon of working function is flashing. Set water
temperature is shown on LCD.
2. Control panel instruction:
At setting stage, the set parameter will increase after pressing
. When parameter
is at the max, it will go back to the min. If you press on
all the time, parameter
increases continuously.
At setting stage, the set parameter will reduce after pressing
. When the
parameter reaches the min, it will go back to the max; If you press
all the time,
parameter reduces continuously.
At setting stage, change function by pressing
will change to the selected function.
Press
and unit will go to working state or back to setting state.
3. Parameter setting instruction:
With power on, default setting of above three functions are as follow: boiling water
to 100, boiling extend to 3s. Press the
switch to other parameter settings and the
corresponding icon will be light.
a) When set to boil parameter, the water temperature can be adjusted from 40
o
C to
100
o
C; by 5
o
C intervals.
b) When set to keep warm temperature, the kettle can be adjusted from 40
o
C to
90
o
C; by intervals of 5
o
C; Keeping warm is up to 30 mins. If you do not need to
keep warm, set parameter to “0”, (Keep warm temperature should be lower
than boiling water temperature, otherwise unit will adjust it by itself.)
To Next Page
Loading...
General