6
COMPONENT REPLACEMENT PROCEDURE
Before beginning the service inspection and/or repair you will need to disconnect the power cord
from the Hot & Cold water dispenser and remove the bottle from the reservoir.
1. Remove the insulating seal cork tape from terminal cover.
2. Remove the cover strap xing the terminal cover.
3. Disconnect the lead wire blue and remove the PTC relay from compressor.
4. Now the PTC relay is free.
REMOVE OF PTC RELAY
REMOVE OF THERMO MOTOR
Fig. 2
Compressor
Lead wire yellow
Terminal cover
Cover strap
Thermo motor
PTC relay
1. Remove the PTC relay in accordance with “REMOVE OF PTC RELAY”.
2. Disconnect the lead wire yellow and remove the thermo motor from compressor.
3. Now the thermo motor is free.
Fig. 1
Compressor
Cover strap
Terminal cover
Lead wire blue
PTC relay
To Next Page
Loading...
