20
SJ-43L-A2
SJ-47L-A2
Fig. A-26
(2)-9. Wind up Leading wire sealer as shown in Fig. A-27
Fig. A-25
(2)-8. Set Heater cover on Drain support, and bend top
edge c and d to outside as shown in Fig. A-26.
Fig. A-23
(2)-6. Bend a and b of Drain support al to right angle
(90˚) to set Def. heater ass'y. (Fig. A-24)
Fig. A-22
(2)-5. Wind the Glass cloth tape (3M: No. 27) to lead wire
of Def. heater ass'y. (2 places)
(2)-4. Replace Def. heater ass'y with new one. (2)-7. Stick the longer wire to the Drain support by
aluminum tape (2 pieces), and wind vinyl tape
(2 pieces) to lead wires of Def. heater ass'y by
aluminum tape as shownin Fig. A-25.
Note: Glass cloth tape part shall be both side of Drain
support to protect the lead wire from damaged.
Fig. A-24
Heater cover
Def.heater ass’y
Drain support al
Def. heater ass’y
Glass cloth tape
(W40 x L25)
Glass cloth tape
Wind the Glass cloth tape
more than 2 turns.
360
(40)
(40) 50
Lead wire
+
+
5
5
Drain support al
This side is longer wire
This side is shorter wire
Def.heater ass’y
a
b
To Next Page
Loading...
Need help?
General
