Sharp SJ-D25P-GY

19
SJ-21P
SJ-D25P
3. R-CBOX ASSEMBLY
1. Connect D timer lead ass'y to Defrost timer,
R thermostat.
2. Screw Lamp to Lamp socket. (Fig. A-18)
Fig. A-18
3. Fix Lamp socket with screw, and Defrost timer
with screw.
4. Cover the capillary tube of R thermostat by
Insulating tube and bend them as shown in
FigA-19.
Paper taping
40 X 80
R thermostat
Screw
Insulating tube
100 5mm
+
Lamp socket
R-thermostat
D timer lead ass’y
Lamp
Defrost timer
R-Cbox cover
F-temp. control knob
Warning label
R-air guider ass’y
Insulating tube
Fig. A-17
Defrost timer
D timer lead ass’y
3
4
1
2
R thermostat
Lamp socket
Lamp
15_
2
mm
70_
2
mm
25_ 2 mm
55_
2 mm
55mm
185mm
5
-0 mm
+5
80mm
25mm
View From A
R thermostat
Insulating tube
A
+
15_
2
mm
+
+
+
+
Fig. A-19
NOTE Minimum bending radius is R5.
There should be no gas leakage by reforming
of Capillary tube.
5. Fix R thermostat with screw and make up the
tube of R thermostat as shown Fig. A-20.
Fig. A-20
6. Insert F-temp. control knob to R thermostat.
7. Stick warning label on R-cbox cover as shown
Fig. A-21.
50±2
9±2
R-Cbox cover
Warning label
Fig. A-21
8. Set R-air guider ass'y on R-cbox cover.