21
SJ-21P
SJ-D25P
Fig. A-32
9. Bend e , f , g and h Drain support 2 as shown
in Fig. A-33.
Fig. A-31
8. Set Heater cover on Drain support, and bend top
edge c and d to outside as shown in Fig. A-32.
Fig. A-29
6. Band a and b of Drain support to right angle (90˚)
set Def. heater ass'y. (Fig. A-30)
NOTE
Don't touch on glass tube with bare hand.
Fig. A-28
5. Wind the Glass cloth tape (3M: No. 27) to lead wire of
Def. heater ass'y. (2 places)
Def. heater ass’y
Glass cloth tape
(W40 x L25)
Glass cloth tape
Wind the Glass cloth tape
more than 2 turns.
340 40
40 30
Lead wire
Glass cloth tape
Vinyl tape
Glass cloth tape
aluminum tape
(W40 x L60)
4. Replace Defrost heater with new one.
a
c
b
d
g
h
Heater cover
Def. heater ass’y
Drain support
e
f
this side is longer wire
this side is shorter wire
Drain support
Def. heater ass’y
a
b
7. Stick the longer wire to the Drain support by aluminum
tape (2 pieces), and wind vinyl tape (2 pieces) to lead
wires of Def. heater ass'y by aluminum tape as shown
in Fig. A-31.
Glass cloth tape part shall be both side of Drain
support.
Fig. A-33
Heater cover
Drain support
Heater cover
top edge
Drain support
Def. heater ass’y
A
A
Sec. AA
c
d
To Next Page
Loading...
