Sanitizing &cleaning, Specifications
page 9
9. Sanitizing and cleaning instructions
9.1： Ozone sterilizing
Ozonator works for 12 seconds every 4 hours.
9.2：Cleaning
(1) Unplug the power, remove drain cap and silicon plug, drain out the water from back, then plug
back the drain seal and cap. CAUTION: water may be hot! And do not forget to plug back the seal
after draining.
(2) Mix lemon acid into the water bottle, Each small bag mix with 2.5L water, twist the probe
assembly on the bottle and close door, then plug power to pump water, switch on heating, switch off
cooling, leave for 24 hours。
(3) Drain water out from the water taps, then drain from the drain cap on the back。
(4) Flush the cooler with good water for 3 times by drain water from the taps and drain cap。
10. Specifications
Model SWD-78EHL-BD
Description
Bottom loader Black and stainless panels
Features Cool (Cook) Tap Black - Grey cooking pot Icon
Cold Tap Black - Blue Glass Icon
Hot tap (Toddle safety latch)
Black-Red Latch/Red Cup Icon
LCD display Sensor Touch
Ozone sanitizer
Yes
Switch for Cold
Switch for Hot
Yes,water proof cover
Yes,water proof cover
Carry Handle
Yes
Power rating Rated voltage and range
220V 50Hz (Working range: 160V~240V)
Current <2.5A
Power plug 250V, 10A, 2 pins Euro plug
Main fuse 250V 4A
Heater power 230V/425W ±5%
Compressor Power 70W, Max:<100W
Output/Flow Cold water (<10℃) Output:4 L/h, Flow:2.2L/min
Hot water (>80℃) Output:4 L/h, Flow:1.8L/min
Cook water
Output:NA, Flow:2L/min
Temperature Cold temperature range 3~10℃
Cooling thermostat NTC electronic sensor
Hot temperature range
Constant temperature at setting value
Heating thermostat
NTC electronic sensor
Heater Safety Dry burn thermostat 130℃ bimetal, autorest
High temperature fuse 192℃ OFF
To Next Page
Loading...
