Sharp VC-MH321HM - Page 41

rr
TS
CONNECTING TO THE MAINS
This VCR is suitable only for connection to UK
mains. The unit is fitted with a moulded 3-pin
mains plug with a 3-amp fuse. The VCR does
not have a mains power switch. When
connected to the mains, the unit will draw
current at all times to power the clock. Be sure
to unplug the VCR when it is not to be used for
several months.
TO REPLACE THE FUSE:
You
must
use
a
3-amp
fuse,
marked
(ASTA)
ey
(BSI)
to
BS-1362.
Remove
the
fuse
cover
as
shown.
Replace
the
fuse
and
re-fit
the
fuse
cover
securely
into
the
plug.
Never connect the plug to the
mains without the fuse cover
TO REPLACE THE MAINS PLUG:
If
the
plug
fitted
is
unsuitable
for
the
mains
socket
in
your
home,
cut
off
the
plug,
remove
the
fuse and dispose of the cut-off plug safely.
mains
socket.
If
a
new
plug
is
fitted,
observe
the
wiring
code
supplied
by
the
plug
manufacturer
(and
given
below.)
If
you
have
any
doubt,
consult
a
qualified
electrician.
{}
Severe
electric
shock
may
occur
if
you
connect
the
cut-off
plug
to
a
The
wires
in
the
mains
cable
are
colour
coded
as
follows:
blue
=
neutral,
brown
=
live.
As
the
colours
of
the
wires
may
not
correspond
with
the
terminals
in
your
plug,
connect
the
wires
following
plug
manufacturer's
guide:
@
blue
wire
to
the
terminal
marked
N
or
coloured
black
or
blue.
@
brown
wire
to
the
terminal
marked
L
or
coloured
red
or
brown.
Ensure
neither
the
brown
nor
the
blue
wire
is
connected
to
the
earth
terminal
in
your
plug.
Do
not
allow
water
to
come
into
contact
with
the
power
supply
cord
or
plug.
A
damaged
power
supply
cord
or
loose
plug
may
cause
electric
shock.
Contact
your
SHARP
dealer
or
a
qualified
electrician.
Do
not
use
the
VCR.
37