VCMH80
VC-MH90
8
Synchro Gear, Drive Gear Land Drive Gear
R
Stamp
mechanism
code
\
Top
surface
should
be
Figure
4-55.
Align the
drive
gear’s round hole with the synchro
gear’s triangular (A> symbol. Do this alignment for
both the drive gears.
-
Phase
Matching Point
Figure
4-56.
Note:
Do not over-turn both of the drive gears when the
phase has been matched. These gears are partially
toothless and might come out of mesh with the
synchro gear. In such a case, the phase needs re-
matching.
33
To Next Page
Loading...
