VL-A111S-GB/pp. 027-040; 01/11/12/18:00
G. K. Associates, Tokyo
Useful Features
38
Using the Counter Memory
Use the counter memory feature when you
want to return to the beginning of a particular
scene. The position where the counter was
reset (0:00.00) is stored in memory to make it
easier to return to that point on the tape.
VCR mode
1 During playback, press the MENU
button until
appears.
• If “MEMORY” is not displayed, press the
COUNTER button.
2 Press the MEMORY button to set the
counter to Counter Memory mode.
•“M” will be displayed to the left of the
counter.
5 Press the REW button (C).
• The tape will automatically stop when the
counter reaches 0:00.00.
Notes:
• The FF button (B) can be used in the
same way.
• The tape may stop slightly ahead or behind
the point where you reset the counter to
“M 0:00.00”.
6 Press the PLAY button (D) to view the
desired scene.
Camera mode
1 During recording, press the MENU
button until
appears.
• If “MEMORY” is not displayed, press the
COUNTER button.
2 Perform steps 2 and 3 above.
3 When you are ready to finish recording,
press the REC START/STOP button.
4 Set the Power switch to VCR, then
perform steps 5 and 6 above.
To cancel Counter Memory mode
Perform step 1 above, and press the MEMORY
button. “M” will disappear from the screen.
Note:
• This feature does not work during video search.
3 Press the RESET button to reset the
counter to zero at the beginning of the
scene that you want to return to later.
NTER
COU
-
ORY
MEM
-
SE T
RE
-
ARCH
SE
-
0M0000
SE T
RE
-
EFF.
GAMA
4 Press the MENU button until
appears. When you are ready to finish
playback, press the STOP button (A).
NTER
COU
-
ORY
MEM
-
SE T
RE
-
ARCH
SE
-
01800
EFF.
GAMA
NTER
COU
-
ORY
MEM
-
SE T
RE
-
ARCH
SE
-
0M1831
ORY
MEM
-
EFF.
GAMA
Memory indicator
0M1124
0M0000
REW PLAY STOP ST I LLFF
REW PLAY STOP ST I LLFF
To Next Page
Loading...
