EasyManua.ls Logo

Sharper Image 207155 - Water Level Warnings; Heating Function Operation; Adjusting Water Heating Temperature; Red Light Therapy

Sharper Image 207155
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 2 -
WATER LEVEL WARNINGS
The maximum water level is 60% of the water container or to its maximum water level
indicator
It‘s recommended to fill with water up to 50% of the water container
Never fill the unit with water past its maximum water level. Filling it past the maximum water
level will affect the water jet massage function
NOTE: Be careful not to spill water onto the control panel.
HEATING FUNCTION
The digital display will show the current water temperature
The default maximum water heating temperature is 108 °F once the power is turned on
Adjust the water temperature to your liking (the Automatic Water Temperature Balancing
System will be initiated to automatically turn on/off the heating function to keep the water
temperature at 108 °F)
When its water temperature cools down below 108 °F, the heating function will be turned on
automatically again
NOTE: The heating function will not turn on if the current water temperature is already higher than
its default maximum temperature is 108 °F.
CHANGING THE DEFAULT WATER HEATING TEMPERATURE
Press the TEMP +/ TEMP button to reset the maximum water heating temperature
The highest heating temperature you can set is 116°F
The lowest heating temperature you can set is 95°F
Press the on/off button again to turn the unit off
TEMPERTURE SETTINGS
Use the Temp+/- button to change the maximum water heating temperature while using any
massage modes
Press the TEMP+ button to increase the water heating temperature of your choice. After 3
seconds the current water temperature will display on the digital screen
Press the TEMP - button to decrease the water heating temperature. After 3 seconds the
current water temperature will display on the digital screen
RED LIGHT FUNCTION
Press the red light button to turn the red light therapy on
MASSAGE FUNCTION
Press the massage button to turn the rolling massage function on/off
Choose from three massage modes from slow to fast
Default time for the rolling massage is 15 minutes
NOTE: Water jets are located inside the water container under the control panel. The water jet air
bubbles are stronger when the water level is lower.

Related product manuals