Sharper Image A552 - Sink Cleaning

A552Rev. F 2/15
10
4. Allow the Stainless Steel Filter and Honeycomb Pre-Filter to
dry completely before inserting them back into the Ionic
Comfort
® Quadra unit. They can be dried either in the dishwasher
or allowed to air dry. Typically, evaporative air drying can take
12-24 hours, depending on humidity and temperature.
5. Install the Honeycomb Pre-Filter back into the bottom of the
Stainless Steel Filter Assembly. Don’t worry: both ends are the
same, so it can be inserted either way. Never operate the
unit without the Honeycomb Pre-Filter.
6. Insert the cleaned and dried Stainless-Steel Filter Assembly
back into your Sharper Image
® Ionic Comfort Quadra unit.
If you have reinstalled the Stainless Steel Filter Assembly after
cleaning and drying, and hear “crackling” after turning it on,
your lter is still wet. Turn the unit o, remove the Filter
Assembly and allow it to dry longer.
Note:
Do not allow the dishwasher rack to bend the Stainless Steel
Filter Plates or break the Ionizer Wire. Care must be taken
when positioning in the dishwasher. Your air purier will not
function properly if the Stainless Steel Plates touch each other
or the Ionizer Wire breaks.
CAUTION
Sink Cleaning
Remove the Honeycomb Pre-Filter from the Stainless
Steel Filter Assembly and place both components in your
sink. Rinse to remove large debris. Submerge both lters
in warm water that contains standard dish washing soap.
Allow the lters to soak for at least 15 minutes, drain the
sink and rinse the lters with cold water.
Note:
You may use a small-headed scrub brush to clean
stubborn residue between the Stainless Steel Plates or
Honeycomb Pre-Filter. However, take care not to bend the
Stainless Steel Plates or apply pressure to the Ionizer Wire.
A552Rev. F 2/15
10
4. Allow the Stainless Steel Filter and Honeycomb Pre-Filter to
dry completely before inserting them back into the Ionic
Comfort
® Quadra unit. They can be dried either in the dishwasher
or allowed to air dry. Typically, evaporative air drying can take
12-24 hours, depending on humidity and temperature.
5. Install the Honeycomb Pre-Filter back into the bottom of the
Stainless Steel Filter Assembly. Don’t worry: both ends are the
same, so it can be inserted either way. Never operate the
unit without the Honeycomb Pre-Filter.
6. Insert the cleaned and dried Stainless-Steel Filter Assembly
back into your Sharper Image
® Ionic Comfort Quadra unit.
If you have reinstalled the Stainless Steel Filter Assembly after
cleaning and drying, and hear “crackling” after turning it on,
your lter is still wet. Turn the unit o, remove the Filter
Assembly and allow it to dry longer.
Note:
Do not allow the dishwasher rack to bend the Stainless Steel
Filter Plates or break the Ionizer Wire. Care must be taken
when positioning in the dishwasher. Your air purier will not
function properly if the Stainless Steel Plates touch each other
or the Ionizer Wire breaks.
CAUTION
Sink Cleaning
Remove the Honeycomb Pre-Filter from the Stainless
Steel Filter Assembly and place both components in your
sink. Rinse to remove large debris. Submerge both lters
in warm water that contains standard dish washing soap.
Allow the lters to soak for at least 15 minutes, drain the
sink and rinse the lters with cold water.
Note:
You may use a small-headed scrub brush to clean
stubborn residue between the Stainless Steel Plates or
Honeycomb Pre-Filter. However, take care not to bend the
Stainless Steel Plates or apply pressure to the Ionizer Wire.
Rev. G 5/15