Instructions for Use
1. Plug corded recharger into 120V outlet.
2. Plug small end of recharger cord into the massager’s base. A
red light on the massager illuminates to indicate the unit is in
charge mode. Allow unit 3½ hours to fully charge.
3. Remove the massager from the charging base. Massager runs
45 minutes on a charge.
4. To activate massage, press the
POWER button once.
5. Lightly apply 4 massage nodes to the area you wish to treat.
Massage the area for a short period of time and move to
another area. Never treat the same area for longer than 3
minutes. Caution: Never use this appliance near the eyes or
other sensitive areas.
6. After completing the massage, turn the massager off by de
-
pressing the POWER button once.
Note: Operation for longer than 15 minutes is not recommended.
HF769 IM_v1 0607.indd 9 7/25/07 5:29:43 PM
To Next Page
Loading...
