•Do not expose unit to direct sunlight for long periods of time.
•Protect from water and wear and tear.
•Batteries may need to be replaced if LCD fades or flashes.
Always use fresh batteries.
Assembly
Front stabilizer has two holes. Orient front stabilizer. Use a
wrench or ratchet (13 mm) to secure the carriage bolts and
round-tip hex nuts, attaching the front stabilizer to the main unit
with flat part of rubber feet facing the floor. Make sure the car-
riage bolts do not spin as you tighten the hex nuts.
Rear stabilizer (facing tension dial) has only one hole in the
center. Use a screwdriver to attach stabilizer to main body with
flat parts of rubber feet facing the floor.
Screw right and left pedals onto pedal arms. Be sure to mount
right pedal on right side and left pedal on left side (pedals are
marked with R and L).
Warning
To Next Page
Loading...