Germicidal Lamp Replacement
Oil from fingers will reduce the germicidal performance of the
U.V. lamp. If possible, use gloves or handle only by the metal area
of the lamp. Otherwise, clean the lamp after installing to remove
fingerprints and oils.
To clean: Wipe the lamp, using a paper towel lightly dampened
with rubbing alcohol or an ammonia-based cleaner (such as
Windex brand).
1. Remove the cover by lifting up on
the RELEASE-TAB at the bottom of
the cover and sliding the cover up.
2. Turn the lamp
1
/4 turn (two “clicks”)
and slide it from its fixture. Replace
with a new one of the same type.
3. Dispose of used fluorescent lamps in
accordance with local regulations.
17
Release-Tab
To Next Page