When unit is plugged in, press STANDBY/ON to turn on stereo.
Standby LED turns off and the unit defaults to the last chosen
function.
Setting Clock
1. Press MODE to display the time.
2. Press MEMORY until the hour flashes. Press TUNE/UP and
TUNE/DWN to select the correct hour.
3. Press MEMORY until the minute number flashes. Press
TUNE/UP and TUNE/DWN to select the correct minutes.
4. Press MEMORY again to set the clock. Digits will stop flashing.
Playing CDs
Note: Never put your fingers into the CD compartment when
closing the CD door. If the CD door is obstructed it will stop and
then automatically open after five seconds.
1. Press POWER button to turn unit on.
2. Press CD-1 or CD-2 button to select CD mode. Press OPEN/
CLOSE button to open either CD door. Insert disc by gently
pressing on the center part of the disc so it locks in place with
the label side facing out. Press OPEN/CLOSE to close CD door.
Normal Operation
To Next Page
Loading...