Sheffield PLA0963S - Draining Excess Water; Water Outlet; Extension Hose Use; Starting the Dishwasher

How to Drain Excess Water From H-oses
If the sink is 1000mm hi gher from the floor, the excess water in hoses cannot bed r.a ined directly
Into t~e sink. It_ will be necessary to drain excess water from hoses into a bowl or suitable
container that 1s held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avo id water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Start of dishwasher
The following things should be checked before starting the dishwasher .
II The dishwasher is level and fixed properly
PJ The inlet valve is open
il There is not a leak at the connections of the hoses
!J The wires are tightly connected
~ The power is switched on
ffl The inlet and drain hoses are not knotted
fi All packing materials and printings should be taken out from the dishwasher
A Attention:
After installatio,1 , please 111ake sure to keep tl1is manual .
Tl1e co ntent of this man,1a/ ,s very helpful to the us ers .