AFTER SALES SUPPORT
PROLINK ASIA LTD
Phone: 0508 776 546 - Mon-Fri 8:30am – 5pm Page 7
Attaching the Mixing Bowl
1. Place one hand on top of the Mixer Head and with the other hand press the tilt
button downward as per the arrow. Lift the Mixer Head up until it stops and then
release the “Tilt” button and the Mixer Head will lock into the elevated position.
2. Fit the bowl so that it aligns with the grooves on the Mixer Stand.
3. To lock the mixing bowl, turn it clockwise following “ ” on the Mixer Stand.
Make sure that the mixing bowl is securely locked in place.
Inserting Dough Hook/Beater/Whisk
1. Align the chosen attachment so that grooves on attachment align with the
Attachment Shaft located under the Mixer Head.
With some pressure, push the attachment towards the Mixer Head lifting the
Attachment Shaft spring upwards. Twist the attachment in an anti-clockwise
direction.
Make sure that the attachment is securely locked in place.
NOTE: It is important that the Dough Hook, Beater or Whisk attachment is securely
locked into place on the Attachment Shaft or your Bench Top Mixer will not operate
correctly.
Removing the Dough Hook/Beater/Whisk
1. Lift up the Mixer Head and then hold onto the assembled attachment. With some
pressure, push the attachment towards the Mixer Head lifting the Attachment
Shaft spring upwards. Twist the attachment in a clockwise direction.
Pull the attachment away from the Attachment Shaft to remove it from the Mixer
Head.
To Next Page
Loading...