Frequency: 2412-2472 МHz; (Max. 2483,5 MHz)
RF output power 9,87dBm
Dimensions (HxWxL): 35x45x45 mm
Operational range:
up to 50 m outdoors
up to 30 m indoors
Electrical consumption:
“Sleep” mode ≤70uA
“Awake” mode ≤250mA
Introduction to Shelly
Shelly® is a line of innovative Devices, which allow remote control of electric appliances through a mobile phone,
tablet, PC, or home automation system. All devices use WiFi connectivity and can be controlled from the same
network or through remote access (any internet connection). Shelly® may work standalone on the local WiFi
network, without being managed by a home automation controller, or it can also work through cloud home
automation services. Shelly devices can be accessed remotely from any place the User has Internet connectivity.
Shelly® has an integrated web server, through which the User may adjust, control and monitor the Device. Shelly®
Devices have two WiFi modes – Access Point (AP) and Client mode (CM). To operate in Client Mode, a WiFi router
must be located within the range of the Device. Shelly® Devices can communicate directly with other WiFi devices
through HTTP protocol. An API can be provided by the Manufacturer. Shelly® Devices may be available for monitor
and control even if the User is outside the range of the local WiFi network, as long as the devices are connected to a
WiFi router and the Internet. The cloud function could be used, which is activated through the web server of the
Device or the settings in the Shelly Cloud mobile application. The User can register and access Shelly Cloud using
either Android or iOS mobile application, or with any internet browser at https://my.shelly.cloud/
Installation Instructions
CAUTION! Use the Device only with batteries which comply with all applicable regulations. Inappropriate
batteries may cause a short circuit in the Device, which may damage it.
CAUTION! Do not allow children to play with the device, especially with the Power Button. Keep the devices for
remote control of Shelly (mobile phones, tablets, PCs) away from children.
Battery placement and Button controls
Twist the bottom cover of the device counterclockwise to open. Insert the battery inside before placing the device at
the desired place.
Power Button is located inside the device and can be accessed when device cover is open. (when using USB power
supply accessory power button is accessible through a hole at the bottom of the device with a pin)
Press the Button to turn on AP mode of the device. The LED indicator located inside of the device should flash
slowly.
Press the Button again, the LED indicator will turn off and device will be in „Sleep“ mode.
Press and hold the button for 10 seconds for Factory Settings Reset. Successful factory reset turns on the LED
indicator to flash slowly.
LED Indicator
LED flashing slowly – AP Mode
LED constant light – STA Mode (Connected to Cloud)
ED flashing quickly
STA Mode (No Cloud) or
FW Update (while in STA mode and connected to Cloud)
Compatibility
To Next Page
Loading...