User and Safety guide EN6
ENGLISH
Shelly Motion has a built-in 6500mAh rechargeable battery which
allows the sensor to be connected to the Internet (standby mode)
for up to 3 years without recharging, and in active transmission
(approx. 6 hours/day motion detected) estimated between 12 and
18 months.
Specication
• Working temperature -10 ÷ 50°C
• Radio protocol WiFi 802.11 b/g/n
• Frequency 2400 – 2500 MHz
• Operational range (depending on local construction) up to 50 m
outdoors or up to 30 m indoors
• Battery - 6500mAh 3,7V
Visual indications
The Motion Sensor is equipped with a LED diode, signaling sen-
sor’s operating modes and alarms.
Blue light non blinking Inclusion mode
Red light blink Motion detected and reported
Green light blink
Motion detected, reporting disabled
Blue/Green/Red sequence
Reboot or Vibration detected
Blue light blink Firmware update
Blue light single blink Settings change
Button user interaction
Use pin to press the button as shown at the picture
• Short press (AP mode) - wake-up from AP sleep mode (AP is
only for 3 minute and device power OFF, battery save transpor-
tation mode)
• Short press (STA MODE) - send status
• Long press 5 sec (STA mode) - AP mode
• Long press 10 sec (STA mode) - Factory reset
To Next Page
Loading...