ESP-07S User Manual
3.1. Package information
ESP-07S use a half hole patch package, Module PCB Footprint shown in the following figure:
Figure 5 Module PCB Footprint
3.2. OEM installation mathod
Using ESP-07S module Please reference in front of the package information in the Layout on the main board for
OEM factory .Please pay more attention Module's direction and the antenna close to the edge of board is better ,the
Components and layout should not be on the bottom of antenna then soldering the module.when the module be
soldering can not in the environment of high temperature ,We recommend the reflow soldering temperature curves is
shown in figure 6:
Figure 6 Recommend reflow soldering temperature curves
To Next Page