深圳市宏宇达数控技术有限公司
地址：深圳市南山区中山园路 1001 号 E4-6C(TCL 国际 E 城) TEL：0755-26625800 FAX：0755-26729960
-2-
Thanks for choose HYD products!
SAFETY：(Note:XPTHC-300-3 use AC24V or DC20-36V power supply !)
Please
read this manual fully before use XPTHC-300-PT
DO NOT open cabinet of THC unless trained technician.
DO NOT adjust the sealed resister.
Turn off Power supply if when THC is unused.
DO NOT put liquid on THC.
Attention Anti-dust work, DO NOT let metal dust into THC.
GND Must follow THC instruction, GND resister≤1Ω.
UP/DOWN on THC must be same to Z-axis Lifter
Plasma arc voltage must connect with voltage divider, plasma work + must connect
with workpiece.
DO NOT install the THC in the place of heat source, the normal working temperature of
the regulator is between -10 ~ 60 ℃℃。
To Customer：
We only supply to re-seller as CNC cutting machine manufacturer, engineering
company… end-user please contact our local distributor for product supplying.
We offer technical support to all distributors and users of our product.
。
IMPORTANT NOTE
：
All our THCs have been tested on CNC cutting machine in our workshop before
delivery, all commissioning work was done. Please DO NOT change the setting
without informing your supplier.
ShenZhen HYD CNC Technology CO.,LTD
2016-08-01
To Next Page