B. assemble carrier
1. Place top shell on bottom shell, aligning at the
start of the zippers.
(Fig 4)
2. Connect top shell zipper to the bottom shell
zipper.
(Fig 5)
3. As you finish zipping the shells together the
zipper will overlap itself. Be sure to tuck the
beginning of the zipper underneath the end as
shown.
(Fig 6)
C. attach shoulder strap
1. Unfold the shoulder strap and drape across the
carrier, making sure that the padding is facing
down, the strap is facing up, and there are no twists
in the strap.
2. Feed one end through one of the top webbing loops
at the back of the carrier.
(Fig 7)
3. Slide metal fastener onto the bottom webbing loop,
making sure to go through both layers of webbing
until the fastener is locked in place.
(Fig 8)
4. Pull loose end diagonally across the carrier. Repeat
steps 2 & 3 with the loose end as described above.
(Fig 9)
Note: To wear the carrier on your right side, connect the strap
from the front mesh side to the back pocket side. To wear the
carrier on your left side, connect the strap from the front
pocket side to the back mesh side.
A. Insert support plate
1. Unfold top shell and turn upside down. Find the
pocket on the underside and open the
hook-and-loop closure.
(Fig 1)
2. Holding support plate in one hand, bend to a
curved shape and insert it completely into pocket.
The curved side should push against the top of
the shell to create the domed shape.
(Fig 2)
3. Press hook-and-loop closure to secure.
(Fig 3)
00460-72069-201 page 1
COMFORT RIDE
™
PET CARRIER
a
ZIPPERED SIDE POCKET
BOTTOM
WEBBING LOOPS
POCKET SIDE
MESH SIDE
REMOVABLE LINER
b
d
c
Remove all parts from box and the protective inner bag.
Open the zippered side pocket on the top shell to find the
adjustable shoulder strap and support plate.
TOP
WEBBING
LOOPS
a. Top shell
b. Bottom shell with liner
Locate parts
c. Adjustable shoulder strap
d. Support plate
Fig 1
Fig 3
Fig 2
Fig 4
Fig 5
Fig 6
Fig 7
Fig 9
Fig 8
To Next Page
Need help?
General