%IS
equlpment%nerates very high fluid pressure. Spray from
the gun, leaks or ruptured components
can
inject fluid
through your skin and into your body and
cause
extremely
serious bodily injury, including the need for amputation. Also,
fluid injected or splashed into the
eyes
can
cause'serious
damage.
NEVER
poim
the
spray
gun
at anyone
or
at
any paq
of
the
body.
NEVER
put hand or fingers over the spray tip.
NEVER
try
to "blow back" paint; this is NOT an air spray system.
nerd
Safe
ALWAYS have the tip guard in place.on the spray
gun
when
spraying.
before cleaning or removing
the
spray tip or servicing any
ALWAYS follow
the
Pressure Relief Procedure,
below,
system equipment.
NNER
try
to
stop or deflect leaks with your hand or body.
before each
use.
Be
sure aquipment safety devices are operating properly
?!
TB
edi
I
rmtmetnt
any
UI
amears
to
Denetrate vour skin.
aet
B
sJe
JI
gun
s%*E2Zare operating prop& before
each
use.
Do
not remove or modifv anv
Dan
of
the
wn:
this
ra
G
n
8af
can
cause
a
malfunction and result'in
&Nous
bodilykju.ry.
Safety
Latch
the
gun
safety latch in the closed or
"safe"
position. making
'Whenever you stop spraying, even for
a
moment, always
set
the
gun
inoperative. Failure
to
set
the safety latch can result in
accidental triggering of the gun.
Diffuser'
Te
gun
diffuser breaks up spray and reduces
the
risk of injec-
hon
when the tip
is
not installed. Check diffuser operation
regularly. Follow the Pressure
Relief
Procedure, below,
then
remove the spray tip. Aim the
gun
into
a
metal pail,
pmsure. trigger the gun.
If
the fluid emitted
is
not
diffused in-
holding the
gun
firmly to the pail. Using the
lowest
possible
to an irregular stream, replace the diffuser immediately.
nip
Guard.
ALWAYS have the tip guard in place~on the spray
gun
while
spraying. The tip guard alerts you to the injection hazard and
helps prevent accidentally placing your fingers or any pan of
your body dose
to
the spray tip.
a
Ti
Safe81
e&&
cautio when cleaning or changing spray tips.
If
the spray tip clogs while spraying, engage the gun safety latch
immediately. ALWAYS follow the Pressure
Relief
Pro-
cedure
and
then remove the spray tip to clean
it.
NEVER
wipe
off
build-up around the spray tip
until
pressure
is
fully relieved and the gun
sa+ty
latch is engaged.
e
thegun safetylatch.
(51
Hold
prensura.
(61
Engage
the
gun
If
YOU
suspect
that the
spray
tip
or
hose
is
completely dogged,
or
that
pressure
has
not
been
fully relieved
after
following
the
Steps above.
VERY
SLOWLY loosen
the
tip guard retaining nut or hose end coupling and relieve pressure gradually, then
loosen
completely.
Now
dear the tip or hose.
pi
ENGAGE
SAFETY
TURN
SWITCH
TO
OFF
UMPLUG
CORD
DISENGAGE
SAFEW
AND
TRIGGER GUN;
ENGAGE
SAFEW
AGAI~~
OPEN
DRAIN
VALVE
..
To Next Page
Loading...