Shimano Steps DU-E5000 - Connecting the Speed Sensor

31
Installing the drive unit and peripheral parts
Connecting the speed sensor
1. Connect the electric wire to the drive unit's E-TUBE port.
Connect the wire from either the cycle computer or junction [A]. Use junction [B] to also
connect the wire from the electronic gear shifting component (rear derailleur or motor
unit).
Electric wireE-TUBE port
NOTICE
• Be sure to attach dummy plugs to any unused E-TUBE ports.
Connecting the speed sensor
Connect the speed sensor's electric wire to the drive unit's terminal block.
1. Connect the electric wire to the drive unit's speed sensor port.
Speed sensor port Speed sensor electric wire