Shimano CJ-8S40 - Disconnecting the shifting cable

CJ-8S40
JAPAN
LOCK
1
CJ-8S40
JAPAN
LOCK
CJ-8S40
JAPAN
1
LOCK
CJ-8S40
JAPAN
Cassette joint
Disconnecting the shifting cable when removing the rear wheel from the frame
If it is difficult to pull the outer casing holder out
from the outer casing holder section of the
cassette joint, insert a 2 mm Allen key or a #14
spoke into the hole in the cassette joint pulley,
and then turn the pulley to loosen the inner cable.
Then remove the inner cable fixing bolt unit from
the pulley first, and after this remove the outer
casing holder from the outer casing holder
section.
Note:
Do not remove the cable by pulling the outer
casing.
Note:
If reusing the cable, refer to steps 6 to 8 in
"Installation of the shifting cable"
.
Remove the inner cable fixing bolt unit from the
cassette joint pulley.
1
Set the shifting lever to .
Hold the rubber cover and pull the outer casing holder
out from the outer casing holder section of the
cassette joint. Then remove the inner cable attached
to the rubber bellows from the slit in the bracket. Be
careful not to damage the rubber bellows at this time.
Set to
1
Rubber cover
Rubber bellows
Pull out the
outer casing
holder
Cassette joint pulley
Inner cable fixing bolt unit
2 mm Allen key
or #14 spoke
Pulley hole
2
3
Remove the inner
cable fixing bolt unit
Remove the
outer casing
holder
Turn the
pulley
Remove the
rubber bellows
from the slit
Disconnect the cable from the cassette joint when
removing the rear wheel from the frame.
2
1.
2.
3.