CM-1000 BASIC OPERATION
1. BEFORE POWERING UP YOUR SHIMANO SPORT CAMERA:
2. POWERING UP YOUR SHIMANO SPORT CAMERA:
Unlock and open the back cover, using the
USB cable included connect to power source
and completely charge the unit, insert a Micro
SD/SDHC card (not shipped with camera),
close hatch and
ensure the lock/unlock
switch is returned to the lock position.
** Micro SD/SDHC Card - Class 6 or higher
and maximum of 32gb capacity.
There are two ways to power up your
Shimano Sport Camera.
1) Press and hold the MODE button until two-
beeps sound - this puts the unit on “stand
by” for further user input i.e. setting up WIFI,
selecting shooting modes and recording.
2) Press and hold the RECORD button for 1
second - this will power up the unit directly in
to RECORD mode.
A continuous “beeb” will sound and red light flash on the LED display if card
not installed correctly on start up.
When the camera is first powered up the LED lights will indicate battery levels (left)
and available space left on memory card (right). See below.
FLASHING GREEN LIGHT = CHARGING
FLASHINGFLASHING
Estimated SD Card storage (4GB demonstrated)
To Next Page
Need help?
General