To Next Page
L
Lisa ClementsAug 12, 2025
What to do if my Shimano Bicycle Accessories show error ID799?
- SSandra ObrienAug 12, 2025
If your Shimano Bicycle Accessories display error ID799, update to a supported BOSCH eBike Drive Unit version of the software.
What to do if my Shimano Bicycle Accessories show error ID799?
If your Shimano Bicycle Accessories display error ID799, update to a supported BOSCH eBike Drive Unit version of the software.
What to do if my Shimano Bicycle Accessories show error ID726?
If your Shimano Bicycle Accessories show error ID726, try the following: 1. Turn off the power, check the electric wire connection, and then turn the power back on. 2. Check the product related to the gear shift using E-TUBE PROJECT. If the situation persists, the electric wire might be damaged and you should consult an agency.
What to do if my Shimano Bicycle Accessories show error ID727?
If your Shimano Bicycle Accessories show error ID727, here are some steps you can take: 1. Turn off the power, check the electric wire connection, and then turn the power back on. 2. Check the shift switch of DI2 with E-TUBE PROJECT. If the problem continues, the electric wire might be damaged; consult an agency.
What to do if my Shimano Bicycle Accessories show error ID700?
If your Shimano Bicycle Accessories display error ID700, follow these steps: 1. Turn the power on again. 2. Perform an E-TUBE PROJECT Error Check in single part condition. 3. Replace the DI2 Adapter B. If the problem persists, the DI2 Adapter B might be damaged. Consult an agency.
What to do if my Shimano Bicycle Accessories show error ID724?
If your Shimano Bicycle Accessories display error ID724: 1. If the rear derailleur is connected, check the adjustment bolt and adjust its tightness. 2. Check the product related to the gear shift alone with E-TUBE PROJECT. If the issue continues, the electric wire might be damaged. Consult an agency.
Why is my Shimano Bicycle Accessories showing error ID729?
If your Shimano Bicycle Accessories are showing error ID729, change the switch mode from assist mode switch to gear shifting switch with E-TUBE PROJECT.
What to do if my Shimano Bicycle Accessories show error ID725?
If your Shimano Bicycle Accessories display error ID725, check the SEIS* compatibility chart. If a product not on the SEIS* compatibility chart has been connected, remove or exchange it for a compatible product. Other models may also be compatible with the DI2 Adapter B by updating the firmware; update all the connected SEIS* firmware via E-TUBE PROJECT to the latest version.
What to do if my Shimano Bicycle Accessories show error ID720?
If your Shimano Bicycle Accessories display error ID720, check the BOSCH eBike Drive Unit. Refer to 'Compatibility Chart' on page 6. Or consult an agency.
Key safety guidelines, warnings, and notes for product usage and installation.
Chart detailing component connections and system compatibility.
Diagram illustrating the electrical connections of the system components.
Enumerates the specific tools required for product installation.
Step-by-step guide for installing the DI2 Adapter B.
Procedures for correctly installing the drive unit component.
Instructions for mounting and connecting the shifting switch.
Guidance for installing the motor unit of the system.
Steps to connect the system to a PC for firmware updates and settings.
Details common error codes and recommended actions for troubleshooting.
General| Brand | Shimano |
|---|---|
| Model | DI2 Adapter B |
| Category | Bicycle Accessories |
| Language | English |
