9
INSTALLATION
List of tools to be used
The following tools are required to assemble the product.
Where to use Tool
Hub nut Adjustable wrench
Brake lever 5 mm Allen key
Shifting lever
RAPIDFIRE Plus 5 mm Allen key
Cover fixing screw Screwdriver (#2)
REVOSHIFT 3 mm Allen key
Cover fixing screw Screwdriver (#1)
Cassette joint Inner cable fixing bolt unit TL-CJ40 (Y70898020)
Installation of the sprocket to the hub
< 7-gear hub / 5-gear hub >
Place right hand dust cap onto the driver on the right side of
the hub body.
Next, install the sprocket and secure it in place with the snap
ring.
Specifications
Applicable sprockets
Outward
assembling
Inward
assembling
7-gear 16T - 23T 18T - 23T
5-gear 16T - 23T
Note the
direction
Snap ring
Sprocket
7-gear: Right hand dust cap C
5-gear: Right hand dust cap D
Driver
To Next Page