Shine KITCHEN SES-100 User Manual (English)

Questions and Answers:

W
wendy58Jul 28, 2025
Why is my Shine KITCHEN SES-100 machine not turning on?
- Y
  ymitchellJul 28, 2025
  If your Shine KITCHEN Accessories machine isn't turning on, first ensure the FEEDING CHUTE is locked by rotating it clockwise until the arrow aligns with the lock, as a safety mechanism prevents operation if it's not locked. Next, check the power outlet and toggle the power switch. If it still doesn't turn on, wait 10 minutes and repeat. If the issue persists, contact service@tribest.com with a brief explanation.
A
Ana BerryAug 2, 2025
Why are my Shine KITCHEN SES-100 vegetables not cutting anymore?
- B
  Brent BowmanAug 2, 2025
  If your vegetables are not cutting anymore with your Shine KITCHEN Accessories, it may be time for a replacement blade. If you’ve been frequently using the same blade attachment or using large amounts of produce, the blade may be getting dull.
L
lesliewoodsAug 7, 2025
How to stop my Shine KITCHEN SES-100 Accessories vegetable from spinning?
- R
  Robin IngramAug 8, 2025
  To prevent your vegetable from spinning while pressing with Shine KITCHEN Accessories, make sure it is fully attached to the NO-SLIP VEGGIE GRIP. Attaching only to the pins at the bottom of the PRODUCE HOLDER might not ensure a tight grip.
D
Donna ValdezAug 12, 2025
What to do if my Shine KITCHEN SES-100 FEEDING CHUTE will not click into place?
- T
  Travis GeorgeAug 12, 2025
  If your Shine KITCHEN Accessories FEEDING CHUTE will not click into place, be sure when you are assembling your unit that the blade attachment is fitted down into place completely. If they are pushing up, your FEEDING CHUTE will not be able to click into place properly.
E
Emily LeeAug 17, 2025
What to do if my Shine KITCHEN SES-100 vegetable still has a lot of uncut produce remaining?
- M
  Melissa WilliamsAug 17, 2025
  To address uncut produce remaining after using your Shine KITCHEN Accessories, make sure to push your PRODUCE HOLDER all the way down until the top portion of the PRODUCE HOLDER clicks into place. This should result in only a very small leftover piece.