Shinkawa FK F Series User Manual

77 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

MANUAL No. 6G19-025 Rev.6

Published in Apr. 2020

Revised in Dec. 2022

INSTRUCTION MANUAL

FK-F SERIES TRANSDUCER

Model FK-202F TRANSDUCER



Carefully read and understand this manual before using the product.



After reading this manual, store it in a safe location so that it can be

referenced readily as required.

Table of Contents

Questions and Answers:

J
Jason JohnsonAug 21, 2025
What to do if the Shinkawa Transducer output is 0V and does not change?
- T
  Timothy NortonAug 21, 2025
  If the Shinkawa Transducer output is consistently 0V, there are a few potential causes: * The power might not be turned on. Ensure the power is switched ON. * The wiring may be incorrect. Check the wiring connections to ensure they are correctly wired. * The FK driver could be faulty. If so, replace the FK driver.
C
cantrelljacobSep 1, 2025
What to do if the Shinkawa Transducer output is approximately -22V and does not change?
- J
  Jaime WilliamsSep 1, 2025
  If the Shinkawa Transducer output is stuck at approximately -22V, it could be due to these reasons: * The target may be outside the possible measurement range. Adjust the gap. * The FK driver might be faulty. If this is the case, replace the FK driver.

Shinkawa FK F Series Specifications

General

Brand	Shinkawa
Model	FK F Series
Category	Transducer
Language	English

Related product manuals

Shinkawa CV-862

Shinkawa CV-86 Series