V EXTERNAL CALIBRATION
IMPORTANT: The scale was professionally calibrated before
shipment. It does not recalibrated before use and will not usually
require calibration during its lifetime. However some advanced
users who seek optimum accuracy may wish to calibrate the scale
periodically to maintain perfect accuracy. Incorrect calibration can
occur if you do not follow the steps exactly
1 Press to turn on the scale for warm-up 1-2 seconds
2 Press
to show “0.0” , then press for 3s, it will
show “CAL 0” and “LOAD –XXX g”
3 Place a weight which value equal to the number on the tray
(the showed number is 1000g ,that means you should place a
1000g weight on the tray),,it will display the weight value if
success, then return to the normal weighing.
NOTE: If your scale still does not read accurately, it means that
the calibration is failed and please follow the above steps to
re-calibration slowly.
Please do it on a very stable and flat surface!
VI BASIC SPECIFICATION
Tray
Square size: 155x155mm / Round size : Φ125mm
Display Mode Large LCD display , backlight (optional)
Power supply 4 batteries , or DC adaptor (6V/300mA)(Optional)
Operation Temp.
0-40℃
ELECTRONIC BALANCE
SHINKO GS SERI
Operation Manual
VIBRA SCALES JSC
To Next Page
Need help?
General
