To Next PageTo Next Page
Need help?Do you have a question about the Shoefresh SF50 and is the answer not in the manual?
Select a well-ventilated room for the Shoefresh and ensure air inlets are clear.
Attach shoe holders by aligning the chip with the hole until two bars appear on display.
Place shoes over holders; the unit starts automatically with default sterilization and drying.
This booklet contains practical and technical information about the Shoefresh.
The Shoefresh freshens and dries shoes in two steps: sterilization and drying.
Lists voltage (230V/50Hz/1PH) and power (7-300W) of the Shoefresh unit.
The unit uses ozone for sterilization and then dries shoes, removing odours and tackling bacteria/fungi.
Remove from packaging, attach shoe holders by aligning chip to hole, and check air inlet.
Place the Shoefresh in a well-ventilated room, as ozone can cause issues in confined spaces.
The Shoefresh starts automatically when shoes are placed on holders and shuts down upon program completion.
Adjust sterilization (STZ) time (0-10 min) and drying (DRY) time (0-40 min) and temperature (40-60°C).
Removes odours, bacteria, and fungi. Time can be set from 0 to 10 minutes.
Dries the shoes. Temperature can be set between 40-60°C and time between 0-40 minutes.
Set drying temperature based on shoe material (low for leather, 60°C for sports shoes) and article tolerance.
Manually start or stop the Shoefresh by pressing the + and - buttons simultaneously.
Restore default settings by holding the Settings button for a few seconds.
Always use electrical appliances with care, ensure ventilation, check for damage, and keep away from fire.
Ozone (O3) naturally disinfects, combats bacteria/fungi, and removes odours effectively.
Clean the unit with a damp soft cloth and mild soap. Use a soft brush for air inlets. Do not submerge.
Check plug, socket switch, and circuit breaker. If issues persist, contact service.
Indicates a temperature sensor malfunction. Contact retailer or service agent for examination.
Indicates a blown heater fuse. Contact retailer or service agent for examination.
Indicates a fan malfunction. Contact retailer or service agent for examination.
The ozone generator has malfunctioned. Contact your retailer or service agent for examination.
Check drying temperature and time settings. Ensure items are not too wet; squeeze out excess water.
This can occur from very wet articles. Clean away the water. Use judgement when operating.
Warranty covers manufacturing defects from purchase date. Excludes cosmetic damage, misuse, or unauthorized repairs.
General| Brand | Shoefresh |
|---|---|
| Model | SF50 |
| Category | Household Appliance |
| Language | English |
