Model D3304
Compact Super Heavy-Duty
Workbench Leg System
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz
Introduction
This Heavy-Duty Workbench Leg System features
square-column steel legs with adjustable foot
pads and steel cross braces for unparalleled
strength and stability.
COPYRIGHT © AUGUST, 2016 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in China
Inventory
A. Leg ............................................... 4
B. Brace with Label............................... 2
C. Brace ............................................ 2
D. Adjustable Foot ................................ 4
E. Hex Bolt M12-1.75 x 25 ..................... 16
F. Lock Washer 12MM .......................... 16
G. Flat Washer 12MM ........................... 16
Assembly
We recommend having an assistant hold the
pieces while you assemble the parts. Do not
final-tighten stand bolts until all components
have been assembled.
Specifications
• Size (without top) ....... 32"H x 26"W x 26"D
• Lower Shelf Depth ..........................
3
⁄4"
• Max. Weight Capacity ............... 4000 lbs.
Figure 2. Completed leg assembly.
x 16
To assemble workbench:
1. Attach legs to each side of each brace with
label, ensuring ledges point up. Each set of
pre-drilled holes is attached with a hex bolt,
lock washer, and flat washer (see Figure 2).
2. Attach remaining braces to legs (as shown
in Figure 2).
Figure 1. Completed leg assembly.
Leg
Brace
Brace
with
Label
Figure 3. Completed workbench.
3. Final-tighten all bolts.
4. Install adjustable feet into bottom of
each leg. Once table top is installed, feet
can be further adjusted for stability (see
Figure 3).
Foot
To Next Page
Need help?
General