What to do if my Shoprider Vienna S-UL7 Mobility Aid powerchair fails to operate?
If your powerchair isn't working, check these items: ensure the unit is switched on, the battery level indicator shows a full charge, the freewheel levers are in the drive position, all plugs and terminals are secure, and the joystick is not locked.
What to do if my Shoprider Mobility Aid powerchair stops for no reason?
If your powerchair suddenly stops, first check that the circuit breaker hasn't tripped. If the issue persists, immediately turn off the powerchair and consult your dealer.
What to do if my Shoprider Vienna S-UL7 Mobility Aid needs fuses replaced?
Please contact your local Dealer to ensure the correct sizes are fitted.
User must possess physical, visual, and cognitive skills. Consult dealer if unsure.
Read manual, turn off power when transferring, select slow speed, keep feet on footplate.
Do not exceed inclines, traverse or reverse down inclines, turn suddenly, use in water, carry passengers.
Buttons for powering on/off, sounding the horn, and adjusting speed.
Joystick controls direction and speed. Enters 'sleep' mode after 10 mins of inactivity.
Turn on power, set low speed, use joystick for direction and speed. Release joystick to brake.
Climb 2.5cm (1") kerbs at 90° with backrest upright. Use drop kerbs/ramps if possible.
3-amp charger. Charge for up to 12 hours. Use only supplied charger. Turn off scooter when charging.
Check circuit breaker on battery pack and fuses for overload protection.
General| Maximum Speed | 3.7 mph |
|---|---|
| Overall Length | 42 in |
| Overall Width | 24 in |
| Weight Capacity | 300 lbs (136 kg) |
| Turning Radius | 54 in |
| Overall Height | 36 inches |
| Seat Width | 18 inches |
| Seat Depth | 18 in |
| Battery | 12V x 2 |
| Battery Type | Sealed Lead Acid |
To Next Page
