To Next PageTo Next PageHow to adjust blade guides on Shopsmith 11” Saw if gaps are too wide?
If the gaps between the guide blocks are too wide or the Bandsaw guide blocks are set too far back behind the gullets on your Shopsmith Saw, readjust the blade guides as described in Steps 13-15 of the Adjust the Roller Bearings section.
What to do if the blade lead is strong on Shopsmith Saw?
If the blade lead is strong on your Shopsmith Saw, it could be caused by the uneven set of the teeth. The suggested solution is to have the blade reset and resharpened at a saw shop or replace the blade.
What to do if the blade lead is excessive and interferes with your work on Shopsmith 11” Saw?
If the blade lead is excessive and interferes with your work when using the Shopsmith Saw, you should check the blade guides and then change the angle you feed the work into the blade.
What to do if the guide blocks are worn on Shopsmith 11”?
If the guide blocks are worn on your Shopsmith Saw, grind a new face on the guide blocks as described in Resurfacing the Guide Blocks.
Essential safety precautions and definitions for operating the bandsaw.
General safety guidelines for all power tools, including the bandsaw.
Details the cutting capacities of the bandsaw, including stock thickness and throat depth.
Outlines the electrical needs for operating the bandsaw with different power sources.
Instructions for connecting the bandsaw to its power source, like the Mark V.
Steps for correctly mounting and aligning the drive hubs for power transmission.
Guide on how to properly mount the bandsaw table onto the machine.
Explains the mechanism and importance of keeping the blade properly on the wheels.
Procedure to ensure the blade tension scale is correctly aligned for accurate readings.
Steps for adjusting the roller bearings to ensure proper blade tracking and support.
Guidance on choosing the appropriate bandsaw blade based on material and cut type.
Information on when and how to sharpen bandsaw blades, including professional options.
How to diagnose and fix issues where the blade wanders off the cut line.
Addresses issues related to the bandsaw's overall operation and smooth running.
Solutions for problems related to blade guides, roller bearings, and their alignment.
Common issues with the bandsaw blade, such as "ticks" or breaks, and their solutions.
Problems related to the bandsaw table's tilt, alignment, and stability.
Helps diagnose and correct problems affecting the precision and squareness of cuts.
Solutions for issues causing rough or inconsistent finishes on cuts.
General