E N
Nome file:
7540028EN - CUSTOMER MANUAL SF15_200 TOP EN.docx Rev. 1 12/06/2017
25-28
9 Troubleshooting.
P
ROBLEM
C
AUSE
1
S
OLUTION
2
S
OLUTION
1. Low
flowrate
from outlet
The product is dirty Clean the product.
Please consult a
skilled
technician.
The hydraulic parts are
obstructed or bent.
Fix the hydraulic parts.
The pump has not been primed
correctly.
Prime the pump.
2. The
product
does not
work.
Power supply absent or
insufficient.
Check the presence of a power
supply.
Please consult a
skilled
technician.
The hydraulic parts are
obstructed or bent.
Fix the hydraulic parts
3. Damaged
plastic
components.
Wear. Replace.
Please consult a
skilled
technician.
4. Water
leak
Gaskets or o-rings incorrectly
installed
Check correct gasket and o-ring
installation.
Please consult a
skilled
technician.
5. Sand
inside the
pool.
It is normal to have a little sand
inside the pool after it run for a
while. After a first bottom
cleaning this problem should be
solved.
Clean the bottom.
Please consult a
skilled
technician.
6. Sand
even after
the first
bottom
cleaning.
Sand type too thin.
Make sure the quality of the sand
you purchased it is suitable for
this kind of job.
Please consult a
skilled
technician.
7. Water
leakage from
the draining
pipe.
The tap ring nut is not tightened
properly.
Make sure the pipe o-ring is well
fixed.
Please consult a
skilled
technician.
8. Too much
pressure.
Blocked filter. Clean the filter media.
Please consult a
skilled
technician.
The hydraulic parts are
obstructed or bent.
Fix the hydraulic parts
9. Cleaning
cycles
needed
more and
more closer.
Presence of seaweeds.
Check the eventual presence of
seaweeds in the pool and if
needed add a disinfectant or a
PH level corrective.
Please consult a
skilled
technician.
10. The
pool water is
never bright.
Product not suitable to the
application.
Check the filter and/or the pump
are the right size for the pool
used.
Please consult a
skilled
technician.
To Next Page
Loading...