Step 4
Fit Left Hand Arm (part #500-043) and
Right Hand Arm (part #500-045) by
positioning the axle (smaller diameter)
part of the tube against the hollow tube
across the rear of the Seat Frame (part
#500-021) and sliding into this tube.
The Push Pin (part #500-269) will need
to be pushed in (depressed) to allow
the arms to be fully inserted into this
tube.
Once fully inserted the Push Pin will
“pop out” into the formed slot to lock
the arm into position. This prevents the
arm from being removed again without
depressing the Push Pin.
7 SB6 Roll-in Shower Chair
To Next Page
Loading...