contents
1. let’s get funky
(turning on/off your shoX gold + button control)
2. blinky light thingy
(a guide to the colourful blinky light thingy)
3. hook a brother up
(pairing different devices)
4. get wired
(using the 3.5mm aux cable)
5. play your tunes from your device
(using the usb port)
6. power up
(charging your shoX gold)
7. juice it up
(charging your mobile phone)
2. blinky light thingy
(a guide to the colourful blinky light thingy)
let’s figure out how these blinky lights work…
• is flashing blue – you’re ready to connect to pure
Bluetooth bliss
• is glowing solid blue – you have successfully paired
your device to the shoX gold. well done grasshopper
• is green (aux cable connected) you’re in “get wired”
mode
• is orange (usb connected)
• is red – you’re in “power up” mode (charging your
shoX gold)
now you’re golden
3. hook a brother up
(pairing different devices)
first things first, make sure you are in Bluetooth source;
using the “stby/source” button. The blinky light thingy will
be flashing. when you are connected, the light will stop
flashing. make sure your device and your shoX gold are
within 1 metre of each other
iphones & ipads
• go to general -> Bluetooth & gracefully swipe it to the
“on” position
• shoX gold will become discoverable, touch to connect
• is the blinky light thingy glowing a solid blue? it is?
by george! i think you’ve got it
other cellphones & tablets
• turn your bluetooth on and search for “shoX gold”
• if you’re prompted for a password, enter “0000”
• check your Bluetooth device list & connect with your
shoX gold
1. let’s get funky
(turning on/off your shoX gold + button control)
it’s time for the gold to shine. don’t worry, you got this. just
press the “stby/source” button on the top of your shoX
gold. now a blue light should be flashing next to
“Bluetooth”. see it? great! so you want to switch between
Bluetooth, aux & usb? simply press the “stby/source”
button. turn it off by holding down the “stby/source” button
for 3 seconds.
now a bit more about those stylish track controls and
analogue dials:
play or pause your beats / hold down to disconnect
Bluetooth connection in “Bluetooth” mode
press to skip to the next track/ press & hold to go back
one track
volume dial – to pump up or tone down those tunes
bass dial – for those songs that are all about that bass
treble dial – to control the treble of your tracks
(flip the page over
to continue...)
/
BLUETOOTH
BLUETOOTH
AUX IN
USB
POWER
pure Bluetooth bliss
Brought to you by:
www.tevo.co.za | info@tevo.co.za
0861 77 88 88
To Next Page
Need help?
General