Shua X6 - Moving Instructions; To Move the Treadmill

6 / 27
Step 6:
Use Hexagon wrench to fix #4 into console. Screw it tight after 4 screws are screwed.
Notice: set #4, #3 into console position. Put #4 into console tightly and screw it. And it takes 2 persons to screw it.
16
03
04
Step 7:
A: Use Hexagon wrench and open spanner to tighten #13, #14.
B: Use the motor hood (#11) and screws (#12) that are disassembled at step 1, use Phillip screw driver to fix
#11 into #1, and screw it tight.
Notice: Put #11 into 1 at a certain angle. Please set gently into #1 in the middle of post at a certain angle and adjust
the position. Finally, screw it tight.
13
14
12
12
14
13
11
12