2
TROUBLESHOOTING
1. Unscrew the housing from the miniature plug on the
A96F to expose the wires inside the connector.
2. Use wire clippers to cut and remove the wire between the tip
and ring leads (see figure below). Make sure to remove the
wire completely from between the leads so that there is no
contact between the tip and ring.
3. Reassemble the plug.
If the microphone still does not work, contact Shure Application
Engineering at 1-800-516-2525. Please have the camcorder user's
guide available.
Ë
RING
TIP
Remove wire here
To Next Page
Loading...
