Shure BRH50M - Model Variations; BRH Broadcast Cable Accessories

Shure Incorporated
7/13
Replacement cable for BRH headset  terminates to XLR3M and 1/4 in. Neutrik con
nectors (25 ft. length)
BCASCA-NXLR3QI-25
Replacement cable for BRH headset - terminates to XLR4M Neutrik connector (7.5
ft. length)
BCASCA-NXLR4
Replacement cable for BRH headset - terminates to XLR5M Neutrik connector (7.5
ft. length)
BCASCA-NXLR5
Replacement cable for BRH headset - terminates to XLR4F Neutrik connector (7.5
ft. length)
BCASCA-NXLR4-FEM
Replacement cable for BRH headset - unterminated (bare whip) (6.5 ft. length) BCASCA-1
Model Variations
BRH50M Dual-Sided Broadcast Headset BRH50M
BRH50M Dual-Sided Broadcast Headset (without cable) BRH50M-LC
BRH Broadcast Cable Accessories
The following tables describe wiring for BRH detachable cables. All BRH detachable cables contain six conductors with dis
crete termination at the Shure 6-pin connector that plugs into the headset. For pre-terminated cables, conductors (and signal)
are tied to common contacts at the other end of the cable where shown.
Connector Pin Diagram
BCASCA-NXLR4 (male connector)
4-Pin XLR-M Signal Wire 6-Pin Headset Connector
1 Mic − Black 2
2 Mic + Red 1
3
Mic Ground Shield (uncoated) 3
Headphone Audio Ground White 6