CUSTOM EARPHONE SLEEVES
Those who use earphones regularly for extended periods of time often nd
custom-t molded sleeves offer the best comfort and sound isolation.
Ask a Hearing Health Care Professional about creating custom molded
sleeves for your earphones. For more information, contact:
FURNISHED ACCESSORIES
• Deluxe Carrying Case
• Fit Kit: contains foam, soft ex and triple ange sleeves plus cleaning tool
Sensaphonics Hearing Conservation Toll Free: (877) 848-1714
660 N. Milwaukee Avenue In Chicago: (312) 432-1714 (ph)
Chicago, IL 60622
e-mail:saveyourears@sensaphonics.com
www.sensaphonics.com
TECHNICAL SPECIFICATIONS
Transducer type Low mass/high energy
Sensitivity (at 1kHz) 113.5 dB SPL/mW
Impedance (at 1kHz) 29 W
Output connector Gold-plated 3.5 mm (1/8-inch) stereo plug
Cable length GR -157 cm (62”)
W -157 cm (62”)
K -141 cm (56”)
Net weight 28 g (0.9 oz)
ACCESSORIES
For information about earphone accessories (listed below) and other Shure
products visit: www.shure.com
• Replacement Sleeves • Extension Cables
• Carrying Cases • Push To Hear (PTH)
• Adapters • Volume Control
CERTIFICATION
Eligible to bear CE marking.
Conforms to European EMC Directive 89/336/EEC.
Meets applicable tests and performance criteria in European Standard
EN 55103 (1996) Parts 1 and 2, for residential (E1) and light industrial (E2)
environments.
MAINTENANCE
Careful maintenance ensures a tight seal between the sleeve and nozzle,
improving sound quality and product safety.
Keep the earphones and sleeves as clean and dry as possible.
To clean sleeves, remove them from earphones, gently rinse in warm
water and air dry. Foam sleeves require a longer drying time. Inspect for
damage and replace if necessary.
Ear sleeves must be completely dry before reusing.
Wipe the earphones and sleeves with mild antiseptic to avoid infections.
Do not use alcohol-based disinfectants.
Do not expose earphones to extreme temperatures.
Replace sleeves if they do not t properly.
x
Do not attempt to modify this product. Doing so will void the warranty
and could result in personal injury and/or product failure.
To Previous Page
Loading...
