Thank you for purchasing this fan from SHURflo. Please take a few minutes to read this entire manual before attempting
installation. If you have any questions, please contact your nearest dealer or SHURflo. This unit will work from super low
to refreshingly high speeds in automatic or manual modes at a wide range of temperature settings. Automatic dome-
sensing control allows it to work with most vent covers. Automatic shut-off when it’s raining and motor thermal protection
are just a couple of the exciting safety features of this fan.
Standard & Optional Features
• Variable Speed Fan
• Easy-Remove Screen
• Fits Standard 14” x 14” Roof Openings
• Thermally Protected Motor
• High-Amp Dome Safety Control
• Remote-Control
• Intake & Exhaust Operation
• Motorized Dome
• Automatic Rain Sensor
• Auto-Temp Control from 55°F – 105°F
Contents
• 1 Comfort Air™ Fan Unit, including
-1 upper unit
-1 internal flange & 4 screws
o See specifications on page 6 for
trim model # and sizes
• 1 Remote Control
• 1 Remote Wall Mount & 2 screws
• 1 9-Volt DC Remote Control Battery
• 1 Installation and Operation Manual
Location
• Fan must be installed with the hinge facing
the direction of travel.
• Locate bi-directional fan at least 3 feet from
any exhaust vent.
l Do not install fan in cooking area shown.
Important Information
• SHURflo recommends professional
installation.
• Please read the entire manual before
attempting installation.
• This unit requires 12 VDC Power only.
• This fan uses 4 Amps max.
• 5 Amp fuse recommended.
• Follow all local building / electrical codes.
• Black wire is negative ground [ - ].
• Red wire is positive power [ + ].
• Never reverse polarity. Reverse polarity can
damage circuit board.
• Never turn the fan on with the screen removed.
• Always turn off power before removing screen.
• Never place any objects in moving blade path.
l This unit is not intended for operation during wet
conditions, such as rainy weather or washing the RV exterior.
Operation in wet conditions may damage the product.
Unless equipped with rain sensor option, the warranty will be
void if operated in rainy or wet conditions.
Tools and Materials Required
• #2 Philips screwdriver
• Scraper
• Wire stripper/crimp tool
• Butyl sealing tape (1/8” x 1” x 6’)
• 18 Gauge or larger copper stranded wire
• Insulated wire connectors
• 5-Amp Power
• All weather Silicone sealant
---Rubber roofs require Rubber Roof sealant
• 3/4” or 1” x #8 self-tapping screws [ 28 ] for
roof mounting. Screws removed from old
unit can be used.
Comfort Air™ Fan with Remote
Installation and Operation Manual
!
!
can cut or crush
To Next Page
Need help?
General