Need help?Do you have a question about the SI 3 series and is the answer not in the manual?
General| Brand | SI |
|---|---|
| Model | 3 series |
| Category | Projector Accessories |
| Language | English |
Instructions for removing the trim piece from the motorized screen case.
Steps to disconnect electrical connections before servicing the screen.
Procedure for safely removing the screen assembly from the case.
Steps to remove the motor from the small tube assembly.
Steps to remove the idler from the small tube assembly.
Instructions for safely unpacking a new screen for small tubes.
Steps to install the motor into the small tube assembly.
Steps to install the idler into the small tube assembly.
Steps to remove the motor from the large tube assembly.
Steps to remove the idler from the large tube assembly.
Instructions for safely unpacking a new screen for large tubes.
Steps to install the motor into the large tube assembly.
Steps to install the idler into the large tube assembly.
Steps to install the screen assembly into the motorized case.
Reconnecting all electrical and control cables to the screen unit.
Procedure for setting the screen's lowest operating position.
Procedure for setting the screen's highest operating position.
Final step to install the trim piece and test operation.
To Next Page