Sibo Q896 - User Manual

To Next Page

Wall Mountable Android Tablet PC Q896

1.1 Initial Setup

1. Connect the power and network using one of the following options:

A. Mains Power and Ethernet: Connect the ethernet cable (cable not included) to your network,

then plug the power cable into the tablet pc, as shown in the diagram.

B. POE: If using Power Over Ethernet (POE), connect the ethernet cable (cable not included) to a

powered port on your network, omitting the supplied power cable.

C. Mains Power and WiFi: If using WiFi, plug the power cable into the Tablet PC, omitting the

ethernet cable.

2. Once the power supplies, the Tablet PC auto boots up.

1.2 In-Wall Mounting the Tablet PC

The visible part of the Tablet PC in front of the wall measures 182mm W x 121mm H x 15mm D.

This bracket can also be used for surface mounting using the 75mm x 75mm VESA holes.

1. Make the cutout for the Tablet PC:

A. Make a cutout in the wall 160mm W x 104mm H x 21mm D, or use the in-wall bracket as a

template.

2. Install the mounting bracket into the cutout:

A. Insert the mounting bracket into the wall cutout with the flanges at the bottom. Use 4 screws

(not supplied) to fix the bracket to the wall.

Need help?

Do you have a question about the Sibo Q896 and is the answer not in the manual?

Summary

Details connection methods: Mains Power/Ethernet, POE, and Mains Power/WiFi.

Describes the tablet PC's automatic boot process after power is supplied.

Instructions for making the necessary wall cutout for the tablet PC mounting.

Steps for properly installing the mounting bracket into the wall cutout.

Connects ethernet/power cables and attaches the tablet to the mounting bracket.

General